Cable routing when one processor installed
Figure 504. SAS/SATA cable routing
Figure 505. NVMe cable routing
From To From To
1 Backplane 1: SAS 0,
SAS 1
1 16i adapter
• Gen 4: C0
• Gen 3: C0C1
1 Backplane 1: NVMe 8-9
1 Onboard: PCIe 2
2 Backplane 1: SAS 2
2 16i adapter
• Gen 4: C1
• Gen 3: C2
2 Backplane 1: NVMe 10-
11
2 Onboard: PCIe 1
Front backplane: 8 SAS/SATA + 4 NVMe
This topic provides cable routing information for the front (8 x 3.5-inch SAS/SATA + 4 x 3.5-inch NVMe)
configuration using the 12 x 3.5-inch AnyBay front backplane.
•
“Onboard connectors” on page 455
• “8i RAID/HBA adapter” on page 457
Onboard connectors
The following shows the cable connections for the front (8 x 3.5-inch SAS/SATA + 4 x 3.5-inch NVMe)
configuration with onboard connectors.
Connections between connectors:
1 ↔ 1 , 2 ↔ 2 , 3 ↔ 3 , ... n ↔ n
Cable routing when two processors installed
To connect the processor interconnection cable when two processors are installed, see
“Processor
interconnection cable routing” on page 311
.
Chapter 6. Internal cable routing 455
To Next Page
Loading...
