Lexmark CS725R Service Manual

Options communication error service check
Action Yes No
Step 1
a Check if the firmware is updated, and then update the firmware
if necessary.
b Make sure that the printer supports the option. See the Printer,
Option, and Stand Compatibility Guide.
c Make sure that the option is properly attached to the printer or
adjacent option.
d Reset the printer.
Does the problem remain?
Go to step 2. The problem is
solved.
Step 2
Reseat the printer interface cable on the printer controller board.
Does the problem remain?
Go to step 3. The problem is
solved.
Step 3
Do the following to each option:
a Reinstall the option.
b Print a test page, and then check if the option is defective.
Are all options properly working?
Go to step 4. Contact the next
level of support
Step 4
Reseat the option interface cable.
Does the problem remain?
Go to step 5. The problem is
solved.
Step 5
Check the option interface cable for damage.
Is the cable free of damage?
Go to step 6. Go to step 7.
Step 6
Replace the option interface cable. See
“550-sheet tray interface
cable removal” on page 383.
Does the problem remain?
Go to step 7. The problem is
solved.
Step 7
Replace the option controller board. See
“550-sheet tray
controller board assembly removal” on page 382.
Does the problem remain?
Contact the next
level of support
The problem is
solved.
5028
Diagnostic information
222

Lexmark CS725R Specifications

General

Brand	Lexmark
Model	CS725R
Category	Printer
Language	English