126 and 127 error messages
Error code Description Action
126.01 LVPS line voltage error was detected. See
“LVPS service check” on page 185.
126.02 LVPS line voltage error was detected.
126.06 LVPS 25V line error was detected.
126.07 LVPS 5V rail was down during POR.
126.10 No line frequency was detected.
126.11 Line frequency has gone outside the operating
range.
127.01 HVPS primary power supply was not detected. See
“HVPS service check” on page 185.
127.02 HVPS secondary power supply was not detected.
128 error message
Error code Description Action
128.00 TPS communications error See
“TPS communications service check” on
page 197.
142 error messages
Error code Description Action
142.80 The motor (CM developer) did not turn on. See
“Motor (CM developer) service check” on
page 186.
142.81 The motor (CM developer) did not turn o.
142.82 The motor (CM developer) speed did not ramp up
to the required level.
142.83 The motor (CM developer) stalled.
142.84 The motor (CM developer) ran too slow.
142.85 The motor (CM developer) ran too fast.
142.86 The motor (CM developer) did not run at the
correct timing.
5028
Diagnostic information
171
To Next Page
Loading...
Need help?
General
