Link Communications RLC-4 - Page 7

RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
058: Delete a Command in a Macro .......................................8-9
059: Insert a Command in a Macro .......................................8-9
Chapter 9: Pre-Access Commands ............................................9-1
What preaccess is: ....................................................9-1
What you need to know: ................................................9-1
073: Set/Recall Preaccess ...............................................9-2
074: Allow Access To a Port that Requires Preaccess .........................9-3
075: Set Stop Access Conditions .........................................9-4
076: Recall Stop Access Conditions .......................................9-5
077: Isolate a Port from the Rest of the System ..............................9-5
049: Set Link Access Tone Frequency .....................................9-5
Chapter 10: Not Currently Used .............................................10-1
Chapter 11: The ID System .................................................11-1
How the ID's Work: ..................................................11-1
To Program Your Own ID's: ............................................11-1
More about Programming ID's: ..........................................11-2
ID Timing: .........................................................11-2
085: Enable/Disable IDing a Port ........................................11-3
086: Recall Which Ports have ID's Enabled ................................11-3
Chapter 12: The I/O Interface ...............................................12-1
About the I/O System: ................................................12-1
Logical Input Lines ...................................................12-1
Logical Output Lines: .................................................12-1
Analog Input Lines: ......................................12-2
I/O Connector Pin-Out ................................................12-4
Logical Input Lines .......................................12-4
Analog Input Lines .......................................12-4
Latched Output Lines .....................................12-4
090: Read Whether Input Line is High or Low ..............................12-5
091: Fire Input Line High or Low Event Trigger .............................12-5
093: Turn Output Line On .............................................12-6
094: Turn Output Line Off .............................................12-6
095: Recall Whether Output Line is On or Off ..............................12-7
100: Read Analog Input Line ...........................................12-8
101: Set Resolution For Analog Input ....................................12-9
102: Set Conversion Ratio For Analog Input ..............................12-11
Custom Analog Conversion Ratios: ..........................12-12
103: Calibrate an Analog Input ........................................12-14
104: Set an Analog Alarm ............................................12-15
105: Set Analog Alarm Hysteresis ......................................12-16
107: Recall Analog Lines in Alarm ......................................12-18
108: Recall Analog Line Configuration ..................................12-18
096: Control or Recall Extended Output Lines .............................12-19