RLC-4 V1.79 Copyright © 1998 Link Communications Inc. 9/18/98
Chapter 13: Autopatch Routines ............................................ 13-1
Configuring the Autopatch: ............................................ 13-1
Autopatch Up Commands: ............................................. 13-1
Using '*' for the Autopatch Up Command: ................................. 13-1
Hanging Up: ....................................................... 13-2
Connected Ports: .................................................... 13-2
Predial Digits: ...................................................... 13-2
The Autodialer: ..................................................... 13-2
Limiting Call Length: ................................................. 13-3
How the Dialing Tables Work: .......................................... 13-3
Other Commands that Affect the Autopatch: ............................... 13-4
110: Configure the Autopatch .......................................... 13-5
111: Manual Off Hook ............................................... 13-5
112: Normal Forward Dial ............................................ 13-6
113: Forward Dial with no Long Distance Checking ......................... 13-7
117: Forward Dial with no Long Distance Checking or Predial ................. 13-8
114: Hang up the Autopatch ........................................... 13-9
115: Possibly Hang up the Autopatch .................................... 13-9
116: Set / Recall the Predial Digits and Timing ............................ 13-10
119: Set Allowed Numbers Table Slot ................................... 13-11
120: Recall Allowed Numbers Table Slot ................................ 13-11
121: Set Nuisance Numbers Table Slot .................................. 13-12
122: Recall Nuisance Numbers Table Slot ................................ 13-12
128: Set Full or Half-Duplex Patch Audio for a TX ......................... 13-13
129: Recall Full or Half-Duplex Patch Audio for a TX ...................... 13-13
133: Set up Reverse Patch ............................................ 13-14
134: Reverse Patch Logon ............................................ 13-16
135: Answer Reverse Patch ........................................... 13-16
136: Set up Reverse Autopatch Ring .................................... 13-17
Chapter 14: Doug Hall RBI-1 and RLC-ICM Routines .......................... 14-1
What the RBI-1 is: ................................................... 14-1
What the RLC-ICM is: ................................................ 14-1
Interfacing and Setup: ................................................ 14-1
Using the RBI-1 or RLC-ICM: ......................................... 14-2
139: Set Up the RLC-Icom Interface ..................................... 14-7
RLC-ICM Internal Operation Test Points ................................. 14-10
140: Turn Radio Power On/Off, Set Power and Offset Format ................. 14-11
141: Set PL Frequency, Encode and Decode .............................. 14-12
142: Set Frequency and Offset or Recall Memory .......................... 14-13
143: Recall Frequency and Offset or Memory ............................. 14-14
144: Control/Recall RBI-1 Output Lines ................................. 14-14
Chapter 15: Not Currently Used ............................................ 15-1
Chapter 16: Special Audio Routing Commands ................................ 16-1
037: Set Audio Routing Variable for Commands In a Macro .................. 16-1
038: Kill All Responses Following This Command ........................... 16-2
To Next Page
Loading...