Introduction
3
Organisation
This guide is organised into the following chapters:
■ Introduction
Guidelines provide an introduction to this guide and some general information, including global
contact details for Loma Systems.
■ About Metal Detection
Guidelines provide an introduction to metal detection, including an explanation of the basic
principles and good practice guidelines.
■
Safety First
Guidelines identify explain the safety features built into the machine, potential hazards,
warnings labelling and other general and legislative information related to the safe use of the
machine
■
Technical Specifications
Guidelines provide technical information for the machine to generally assist in the site selection
and safe installation processes
■
Installation
Guidelines explain how to safely install the machine, including the connection of electrical and
pneumatic supplies
■
About the Metal Detector Range
Guidelines provide a summary of the available features and functions of the machine and
descriptions of its component parts.
■
Getting Started
Guidelines describe the basic controls and how to switch on, log in and prepare the machine for
use.
■ The User Interface
Guidelines describe how to navigate around the user interface and also provide descriptions of
the screen through which you can setup and manage all parameters required for inspecting
products and for the general operation of the machine.
■
Using the Metal Detector
Guidelines provide information covering good practice, establishing detector sensitivities and
how to get the best results from your machine.
■
Operating Instructions
Instructions are provided describing how to carry set up and configure the machine, including
adding new products for inspection and carrying out performance validation testing.
■
Logs and Reports
Guidelines identify the types of logs and reports that are available and describe how to output
them for analysis.
To Next Page
Loading...
