About Metal Detection
16
Update Learn
The Update Learn process again consists of
following on-screen instructions to pass a
number of product samples through the
detector aperture. This process can only be
used for products that have already gone
through a Full Learn process. A warning
dialog will pop-up to inform you that a Full
Learn is required if this has not been
completed previously. See the Learning
Products section for further details.
Reverse Learn
The Update Learn process consists of
following on-screen instructions to pass a
number of product samples through the
used to pass products that are identified as
containing a metal contaminant and reject
products that do not.
For example, a product may contain a metal
toy so the detector is used to pass products
which contain the toy and reject those that
don't.
Learn Setup
You are able to make some manual adjustments to the Learn process settings, either before or after
carrying out a Learn process. See the Learn Setup
screen for further details.
General configuration of the Learn processes is carried out in the Auto-Learn Settings screen.
To Next Page
Loading...
