Getting Started
66
Emergency Stop
To stop the machine in an emergency, proceed as follows:
1.
Press the red Emergency Stop button, located on the front of the Electrical Services Box.
The conveyor will then automatically stop.
Starting the Machine after an Emergency Stop
To start the machine after an emergency stop, proceed as follows:
1. Ensure that any issue that caused you to stop the machine has been cleared.
2.
Turn the red Emergency Stop button clockwise and then release the button which will then
pop out to its original position. The power supply to the conveyor is now restored.
3. Push the green section of the Start/Stop button to restart the conveyor.
4. The machine is now ready to start inspecting the selected product.
To Next Page
Loading...
