REAR
SUSPEWSlOell
Page
D8
.::EL
BEARINGS
To Remove
1.
Remove bearing housing and drive shaft assembly as previously described.
2.
Remove the hub as described in Section
G.
3.
With the bearing tlousing/driveshaft assernbly on the bed of
a
press, press
out the driveshaft assembly from the outside (hub side) of
the housing.
4.
Remove both oil seals and the circlip securing the bearing.
5.
Using a suitable spaca
(e.g.
a length of tube) press outer track of bearing
from the housing.
I
Cone
Spacer
Fig.5 Hub bearing
To Next Page
Loading...
