FUEL
SYSTEM
Page
L5
WARNING:
Do not use a probe or wire to clear the jets as this may enlarge
or
damage the jet orifice.
3.
Remove the screws retaining the float chamber coven.
4.
Remove the remaining jets and as in
'2'
above. Note that the pump jet
is
concealed beneath o plug on the outside of the carburetter, in front of the
identification panels.
5.
Clean the floats, float chambers and needle valves with petrol, and blow
clean with an air line.
6.
Check the float level and ensure floats are free to move. Replace all jets.
Using new gaskets, replace the
flwt chamber and jet covers. Check
condition of
'0'
rings on pump and idler jet assemblies, and replace
if
necessary.
Zenith Carburetters
1
Remove the carburetters from the engine.
2.
Remove and clean the float chambers, floats and needle valves with petrol
and blow clean with an air line.
3.
Reploce the needle valves and floats, and check the float level.
Ensure the
floats are free to move. Using a new
gasket, reploce the float chambers.
4.
Using new goskees, replace the carburetters on
the
engine.
?.
All
Engines
v
1.
Using on air line, blow throu
g
h the disconnected fuel supply pipes. Refit
the pipes.
2.
Fit o new fuel filter if necessary.
FUEL
TANKS
1.
Remove engine cover.
2.
Remove engine compartment floor pclnels eoch side
of
the eng ne.
3.
Disconnect and remove battery.
4.
Drain the tank by disconnecting the flexible cross feed pipes under the tonks.
5.
Disconnect
the
pipe between the tanks and the pump.
ESPRIT
Issue
04/78
To Next Page
Loading...
Need help?
General
