BODY
page
B39
Secure the clips with a
0.125
in
(3.17
mm) pop
-
rivet, then seal the
head of the rivet with o smear of
seolont.
3.
Apply a
0.75
in
(20
mm) wide band of 'Solbit' primer round the
periphery of the screen and the body aperture.
Glass
I
Fig
16
-
Section through windscreen and fixing clips
4.
Strip the ends of the 'Solbit' sealing/retaining medium to expose
approximately
12
mm
(.5
in) of the internal heating wire. Connect
the exposed ends to a variable current
transformer (or two
12V
batteries), and apply approximately
24
volts to the 'Solbit' until the
surface
is
tacky. Disconnect 'Solbit' from transformer.
Fig.
17
-
'Solbit' retainer in position
i'h
'>
5.
Starting at a lower corner of the aperture, apply the 'Solbit' to the
primed body flange. The
'Solbit' must be positioned over the flat
ESPRIT
To Next Page
Loading...
