HEATING/WENTPLATION
Page
P3
A two position fan switch increases the air flaw speed, the first position being 'slow'
speed and the second
'fost' speed.
Typical heater control positions are as follows:
Defrost
Move upper lever to the centre position.
Move lower lever backwards to the 'hot' position.
Switch fan speed switch to Fast.
Close
face level vents for best defrost performance.
Hot air to screen and footwells
Move upper lever midway between the two arrow marks.
Move lower lever backwards to the 'hot' position.
Select fan speed to suit.
Hot air to
footwell
Move upper lever to the forward position'(l.
Move lower lever backwards to the 'hot' position.
Select fan speed to suit.
Cold air to
footwell
Move upper lever to the forward positionv.
Move lower lever forwards to the 'cold' position.
Select fan speed to suit.
U'
HEATER
UNIT
ASSEMBLY
To Remove
1.
From inside the front compartment remove the twin blower unit side panels
to reveal the four screws securing the blower unit.
2.
Unscrew the four screws securing the twin blower unit to the bulkhead.
3.
Disconnect the electrical connectors to the blower unit ond lift out blower.
4.
Release the clips securing the flexible ducting to the heater box ond unscrew
the
clips on the water pipes.
Place a suitable container under the heater
water connections to catch any water which will drain from the pipes and
heater when disconnected.
5.
Disconnect the binacle heater controls at the heater box assembly.
To Next Page
Loading...
