BODY
Psge
B47
TO
REPLACE
1
.
Reverse the removal procedure.
SAFETY
BELTS
The seat belt reel assemblies are located in the engine compartment and are fitted to
the back of the bulkhead, one on each side.
TO
REMOVE
1.
Prise off the small cover, near the bottom of the reel:assembly, to
gain access to the fixing bolt. Remove the
red assembly fixing bolt
(A)
and the lower anchor bolt at
(C).
2.
Slide the belt fastening clip off the end of the belt (lower anchor
plote). Feed the lower anchor plate through the feed slot in the
bulkhead. Take care not to damage the feed slot trim when
pulling
throu
g
h belt and anchor plate.
3.
Remove the belt lock from the chassis centre section, by removing
the screw at
(B)
and disconnect the 'Fasten Seat Belt' warning lamp
wires
.
TO
REPLACE
1.
Reverse the removal procedure, taking care the reel assembly
is
mounted vertically, this ensures the sensing weight
is
in the correct
position.
NOTE:
If
a new reel assembly
is
fitted, check the belt runs from the reel the
correct way up. The belt can be mode to run up the other
wapSy pulling
the belt out as far
as it will go, foldin
g
the belt diagonally on itself and
allowing the belt to return on the reel, carefully feeding the double layer
until it clears the slot.
ESPRIT
Issue
04/78
To Next Page
Loading...
