tIIUBS,VVHEEL,TVRES
Page
G4
Fig.1 Front hub
4.
Refit the brake caliper and tighten the mounting bolts to their specified
torque loading.
5.
Refit the road wtieel and tighten nuts to their specified torque loading.
NOTE:
All
Specifications and Torque L.oadings will be found in
TECHNICAL DATA.
REAR HUBS
To Remove
1.
Remove the road wheel, split pin and hub retaining nut.
2.
Tap loose, and remove the cone spacer.
3.
Using a suitable puller, remove the hub from the spline on the driveshaft.
To Repluce
1.
Slide hub on to the driveshaft spline.
Check that the ground surface of the
shaft and the cone
iriner bore of the hub, the surface of the castellated nut
and spacer are
ALL
PERFECTLY CLEAN AND
FREE
FROM
GRIT,
ETC.,
then
ESPRIT
Issue
04178
To Next Page
Loading...
