Lotus Esprit Series - Fitting of New Brake Pads; Rear Brake Adjuster

BRAKING SYSTEM
Page J9
Fig.4 Rear brake adjuster
Fitting of new brake pads
When the brake pad linings have worn to
2 mm, the pads should be replaced. Always
W
fiY new pads in axle sets.
Unscrew and remove the 2 retaining self - lockin
g
screws fram the primary and secondary
bolts with 13 8 17 mm spanners. Take care that the dust - covers are not damaged.
After removal
of retaining screws, the hydraulic hoi~sin~ can rodially be removed and
ppds pulled out. Support the calipers in such a woy to relieve any strain on the brake
hose. Before fitting new pads, clean the area where the new pods are to be seated
but take care
nci to damage the dust - covers. Enst~re that the dust - covers and retain -
ing rings are in good condition and fitted securel
y
. While pushing primary and
c.
secondary bolts bacc'into position, check for easy movement and release trapped air
fram the dust - covers by lifting edge.
If the primary and secondary bolts prove difficult to move, completely remove
together with the dust
- covers. Clean all parts with GlRLlNG cleaning fluid or
-
ESPRIT
Issue 04/78