Lotus Esprit Series - Choke Control

Fig. l6 Air cleoner
CHOKE CONTROL 4. ,... 4
. .
To Remove
-.
1.
u~sconriecr ine inner cabie ai ihe ca+~urriirr>.
2.
Remove the tunnel top assembly, gearlever knob and switch panel assembly.
3.
Pull up choke control on the tunnel switch panel exposing the inner cable
end, pull cable through.
The outer casing is removed by first releasing it at the
carburetters clamp,
e
4.
then releasing the clamp under the carpet on the tynnel housing and before
pulling out outer casing see 'To Replace'.
To Replace
1.
Replacement of the inner cable is the reversol of the removal procedure.
cr.
To replace outer cable, first attachthe ,q new outer cable to the old and then
pull through, pulling through
@'new outer coble.
. .. *.;:L<
. .
...I
-,
. .
:l$ $:
.?
a
ESPRIT
~SSU~ 04/78