HEATING/VENTILATION
Page
P2
GENERAL DESCRIPTION
The heater
unit
is
designed to deliver fresh cir to either the windscreen for demisting,
or to
the interior of the vehicle, or a proportion to both, at any temperature between
cold and hot dependent upon the position of the controls.
/n addition to the above there are two independent face level vents, one in the
scuttle sill and
one in the binacle. These will deliver unheated air at ambient
temperature by the ram effect of the vehicle when moving and
is
independent of the
heater.
OPERATION
OF
CONTROLS
The air temperature
from the heater
is
contrilled by the lower lever. Air temperature
is
varied between hot, with the lever fully back, and external air (cold), with the
lever fully forward.
Air flow to the screen and
footwells
is
controlled by the upper lever in the followin
g
manner:
LEVER
POSITION
AIR
FLOW
Fully back (OFF)
0
FF
Centre position Screen on1 y
Between centre and fully forward
Screen and footwells
Fully forward
v
Footwel
Is
only
ESPRIT
Issue
04/78
To Next Page
Loading...
