EXHAUST
SYSTEM
Page
S5
k
To Replace
1.
Reverse the remo+o! instructions, apply 'Firegum' or similar, to the pipe
joint. Take care when refitting silencer mounting straps not to domoge
the small heat shield fitted on gearbox mounting plate.
MANIFOLD
To Remove
1.
Disconnect the downpipe from the monifold at the flange joint and discard
the gasket.
2.
Disconnect the downpipe from the front end of the primary silencer and
remove.
3.
Support the engine and release the
LII
engine mounting bracket, if necessary,
to enable removal of the manifold.
4.
Remove the nuts with their plain washers, securing the manifold to the cylinder
head. Remove the manifold and discard the goskets.
To
Replace
1.
Reverse the removal instructions, but use new gaskets ot the manifold to
c
y
linder head and manifold to downpipe flange joints, and new nuts also at
these joints.
Apply 'Firegum' or similar at the downpipe to primory silencer
joint. The clamp on the downpipe to primary silencer joint
must be so
positioned that it will not project below the silencer.
ESPRIT
To Next Page
Loading...
