ELECTRICAL
EQUIPMENT
Page
M4
Fig.
l
Headlamp Trimming screws
2.
Replace the bulbs as necessary, then refit lens, correctly positioning the
fwm rubber seal, securing the whale with the two screws.
Stop/Reor Flasher/Reverse Lamps
Series
I
vehicles
1.
To pin access to the rear flasher and reverse lamps it
is
necessary to
remove the four
screws securing the rear and stop light lens.
This
lens has
lips mauldad along the edges to
awl
off and secure the inner edges of the
other
two
lenses.
2.
Unurew
the two screws retaining the other lens and lift off.
3.
Replace the defective bulb(s). Note that the rear and stop bulb can be
fitted one woy only.
4.
Replace the lenses in the reverse order to above.
belies
li
vehicles
'J
goin access
+:
re
er f!her, reverse lor!ips, reor and stop lights,
lift
1
:
.
.
:.
8:
!t
e
bur
type
fixing on the defective bulb.
To Next Page
Loading...
Need help?
General
