BODY
Page
B62
3.
Clean lan~iriated edges of gloss using a sharp knife.
With the special paper
frorn the
repair kit cut in two, cleon with one half soaked in Wipe Clean
L
No.
4
the perimeter of the glass to the depth of the primer applicator.
Also
clean the edges of the gloss arid the body
flange.
Using the other half of
the s
p
ecial paper su
p
erficiall
y
wipe dry the areas cleaned.
4.
Shake primer container for at least
30
seconds before opening. Pour glass
primer
into plastic container.and push home the insert and felt applicator
into the neck of the container. Cut applicator holder using o
sharp knife
to produce a
20mm wide application of primer around the perimeter of the
gloss.
Fig.
28
Application of Gioss Primer
5.
Apply glass primer around perimeter and lominated edge of glass until a deep
black colour
is
achieved. Allow to air dry until dry to the touch.
NOTE:
In order to cover bus
-
bar connections on the heated toilgate glass,
e
stop the primer short of the tag and gently bend tag upwards. Use
masking tape to continue the line of the primer beyond
the tags
and prime the area. When primer dry remove tape and clean up
edges
if
necessary.
CAUTION:
Should primed surface need repairing, wait
5
minutes for it to
dry before applying
more primer.
6.
Remove the desiccant container frorn the bottom of the sealant cartridge and
cut
application nozzle with stop and outlet to required shape of sealarit bead.
ESPRIT
lcrlln
77/78
To Next Page
Loading...
Need help?
General
