CRANKSHAFT
'V'
BELT PULLEY
To Remove
1.
Remove all the
'V'
belts.
2.
Remove the set screw, spring washer and plain washer from the centre of the
pulley. Pull off pulley, using a proprietary puller
if
necessary.
To
Reploce
1.
Reverse the removal procedure. Check all
'V
1
belt tensions after replacing,
and tighten bolts to the torques specified in TECHNICAL DATA.
CRANKSHAFT SPROCKET
-
-
l.
Set the engine in the timing position.
2.
Remove the camshafts driving belt (toothed belt).
3.
Remove the crankshaft
'V'
belt pulle
y
.
4.
With the aid of Special Tool (17OA), pull off the crankshaft toothed pulley,
-.
ioiiowed
by
ihe beii guide iiange.
I
~ghten the tooi boits fingertight oniy.
Fig.
l7
Using Tool 'l70A' to remove crankshaft sprocket
To Replace
l.
Ensure that the engine has not been turned from the timing position.
2.
Reverse the removal procedure. Check and adjust valve timing, ignition
timing, belt tension and slow running.
ESPRIT
To Next Page
Loading...
