4.
Fit the differential shaft into the housing and position using o tube of 30 mm
inside diometer under a press. Tighten
the bearing loclcing nut
(17)
to
15
kg/m (108 lb/ft). Tighten the grub screw (22) in the locking nut.
5.
Assemble and replace the 'Clutch Bellhousing'
OS
previously described.
DIFFERENTIAL CROWN WHEEL AND
PINION
To Remove
-
1.
Dismantle the 'Differential Shoftr' as previously described.
2.
Using the extmctw 2405
-
T remove the tapered roller bearings from each end
of the crown wheel
assembly.
3.
Remove the eight
rcrem
(6)
securing the crown wheel to the housing and
remove the following:
(a) Crown wheel (14)
ID#
;C3~ei;llB
SBIRRtB
IAl
(
C
)
Planet wheel (2) and thrust washer
(8)
(d) Two satellite cplndlen
(5)
(e)
Satellite gears
(3)
and
stop
washers
(Q)
(f)
Crowhead
(10)
(g)
Other planet wheel and thrust washer.
To Replace
1.
Place in the satellite housing o thrust wosher
(a),
one planet wheel
(3,
one
fixed thrust washer
(9),
one satellite gear (3) and the long spindle
(4).
2
Rotate the planet wheel and check that the point of minimum cleomnce
is
0.1
mm.
If this
is
not
so
replace thrust woshers until the minimum clearance
is
achieved. Remove the satellite and thrust wosher making a note of the
positicm in the housing.
3.
Repeut
1
and
2
for each satellite gear, taking care to fit the crouhwd bwh
(10) to support the short satellite
spindles
(5).
Fit the dowel pin screws
tempomrily to locate the short satellite spindles.
4. Fit all the satellite
gsors
and thnwt washers.
5.
Place the
secand
planet wheel with thrust washer in the crown wheel.
6.
Locate the ~~tellite houalng
in
recess
in
the crown wheel and
flt
the eight
Icrem. Take care the dowel
screws
are fitted in the correct holes.
ESPRIT
Issue
oana
To Next Page
Loading...
