LUBRPC=ATION/IVIAINTENAMCE
Page
08
SCHEDULE
OF
'B'
SERVICE (10,000 MILES, 16,000 KILOMETRES)
Lubrication
Drain
engine arid tror~smission oil and refill with new oil. Fit new engine oil filter.
Lubricate drive shaft
uriiversal joints throttle linkoge arid controls, door locks and
bonnet catches. Lubricate hondbrake linka
g
e.
Engine
Check valve clearances and adjust if necessary. Check torque loading of cylinder
head nuts ONLY
IF
VALVE CLEARANCES REQUIRE ADJUSTMENT. Check toothed
timing belt condition arid tension, adjust
if
necessory. Check conditiori and tension
of all
'V1 belts, adjust
if
necessary. Clean air filter body top cover, and
fit
r?ew
element. Check ignition coritact breaker points condition, settings and adjust
if
.
..
.-
.
.
. .
.
.
L!
?
.
.
.
-
.
..
.
.-
..
..
.
. .
.
7..
.
.
..
.
.
.
.
..
.-""""".,
.
'-..""..
.V
.....
"..
.,...,
.,.,,...,.
..
..l""sl.,./.
.
..
.,I..
Lightly lubricate distributor cam and weights. Check alternator mounting bolts for
tightness. Check and adjust air conditioning compressor belt tension and check
mounting bolk for tightness (when fitted). Check security of all fixings especially
engine mounting bolts, exhaust manifold arid system, and inlet manifold and carbu
-
retter mountings. Check carburetters trumpet riuts for tightness (Dellorto). Check
orid adjust slow running mixture orid idle speed. Check security and cleanliness of
ignition harness
joink iricluding alternator and starter motor connections. Top up
cooling system and check security and condition of all water hoses.
Fuel System
Fit new fuel filter. Check fuel system for leaks, fuel pipe connections on carburetters,
fuel pump and fuel tank for tightness.
Braking System
Check entire system for leaks and operation (includin
g
handbrake), and adjust
if
necessary.
Check security of all brake pipes and vacuum pipe connections. Top up
brake fluid
r.eservoir,
if
low check for cause. Check operation of broke fail/
handbrake warning lamp. Check front and rear broke pads for material remaining;
if
down to
2
mm
(0.08
in) MINIMUM, replace the pads. Check caliper mounting
bolts ore to their specified torque loading.
ESPRIT
!SSUP 04/78
To Next Page
Loading...
