BODY
Page
B36
Cantrail Clips
I'
Fig.
13
-
Side
-
capping rail/finisher
3.
Using a suitable thin blade, cut through the sealant between the body
and capping rail and then carefully lift away the capping roil releas
-
ing it from the finisher.
TO
REPLACE
1.
Clean the body surface where the capping rail
is
to be fitted ond
apply sealant along the lower inner edge of the capping
coil.
2.
Feed the capping rail under the finisher ond check alignment along
the
length and at both ends. Clamp ternpororily in position.
To Next Page
Loading...
