LSIS G100 - Page 336

Index
０
0 – +10 V voltage input
１
-10 – +10 V voltage input
２
24 terminal
2nd Motor Function group Refer to M2 (2nd
Motor function group)
2nd Motor Operation
2nd Operation mode
2nd command source
Shared command (Main Source)
３
3 Phase 200V (0.4-4 kW)
3 Phase 400V (0.4-4 kW)
3-Wire Operation
７
7-segment display
Ａ
A terminal (Normal Open)
A1/C1/B1 terminal
AC power input terminal Refer to R/S/T
terminal
Acc/Dec pattern
linear pattern
S-curve pattern
Acc/Dec reference frequency
Delta Freq
Max Freq
Acc/Dec stop
Acc/Dec time
Acc/Dec time switch frequency
configuration via multi-function
terminal
Maximum frequency
operation frequency
Ad (Advanced function group)
Advanced feature group Refer to AP
(Advanced function group)
Advanced function group Refer to Ad
(Advanced function group)
analog frequency hold
Analog Hold
Analog Hold Refer to analog frequency hold
Analog input
I2 current input
V1 voltage input
Analog output
AO terminal
voltage and current output
AO terminal
AP (Advanced function group)
ARM short current fault trip Refer to Over
Current2
ASCII Code
assembly diagram
Asymmetric ground power
EMC filter
asynchronous communications system
auto restart settings
Auto torque boost
Auto tuning
Auto tuning
All (Rotation type)
All (static)
Tr (Static type)
Automatic restart after reset of a fault trip
condition
Auto-Tuning
Default Settings
auxiliary frequency
auxiliary frequency reference
configuration
auxiliary reference
auxiliary reference gain
Configuration