LSIS G100 - Parameter Initialization

3.3.4 Parameter Initialization
The following example demonstrates parameter initialization using code dr.93
(Parameter Initialization) in the Drive group.
Step
Instruction
Keypad Display
1
Go to code 0 in the Drive group.
2
Press the [ENT] key.
The current parameter value "9" will be displayed.
3
To make the target value "93", press the [▼] key to
change the ones' place value to "3".
4
Press the [MODE] key to move to the tens' place value.
5
To make the target value "93", press the [▲] or [▼] key
to change the tens' place value "9".
6
Press the [ENT] key.
Code dr.93 will be displayed.
7
Press the [ENT] key once again.
The current parameter value for code dr.93 is set to 0
(Do not initialize).
8
Press the [▲] key to change the value to 1 (All Grp), and
then press the [ENT] key.
The parameter value will flash.
9
Press the [ENT] key once again.
Parameter initialization begins. Parameter initialization is
complete when code dr.93 reappears on the display.