LSIS G100 - Page 338

Drive Group Refer to dr (Drive group)
Dwell Operation
Acc/Dec dwell frequency
acceleration Dwell
deceleration Dwell
Ｅ
electronic thermal motor overheating
prevention (ETH)
ETH trip
EMC filter
Asymmetric power
Disable
Enable
Emergency stop trip Refer to BX
Enclosed Type 1
Energy buffering
Energy saving operation
automatic energy saving operation
manual energy saving operation
ENT key
error code
FE(frame error)
IA(illegal data address)
ID(illegal data value)
IF(illegal function)
WM(write mode error)
ETH Refer to electronic thermal motor
overheating prevention (ETH)
Excitation Current
External 24V power source Refer to 24
terminal
External dimensions
0.8–1.5kW(Single Phase), 1.5–
2.2kW(3 Phase)
2.2kW(Single Phase), 3.7-4.0kW(3
Phase)
5.5-22kW(3–Phase)
External trip Refer to External Trip
External Trip
external trip signal
Ｆ
Factory default output
Fan trip Refer to Fan Trip
Fan Trip
Fan Warning Refer to Fan Warning
fatal
fault
fatal
fault/warning list
latch
Level type
major fault
minor fault
trip
warning
Fault signal output terminal Refer to
A1/C1/B1 terminal
FE(frame error)
Ferrite
Fieldbus Refer to Fieldbus
Communication option
Filter time constant
Flux braking
Free-run stop
Frequency jump
Frequency limit
Frequency jump
Frequency upper and lower limit value
Maximum/start frequency
Frequency setting
I2 current input
Keypad
RS-485
V1 voltage input
Frequency setting (voltage) terminalRefer to
V1 terminal
Ｇ
G100 expansion common area parameter
control area parameter (Read/ Write)
memory control area parameter (Read
and Write)
Monitoring Area Parameter (Read
Only)
Ground