LSIS G100 - Page 340

Start frequency
Lost Command
command loss fault trip warning
Command loss trip
Low Voltage
Low voltage trip
low voltage trip 2
LS INV 485 protocol
Ｍ
M2 (2nd Motor function group)
Magnetic contactor
Maintenance
manual torque boost
Master
megger test
Micro surge filter
Modbus-RTU Protocol Refer to
Modbus-RTU Protocol
monitor
Monitor Registration Detailed Protocol
Motor output voltage adjustment
motor protection
Motor rotational direction
mounting bolts
Mounting bracket
multi-drop Link System
Multi-function (open collector) output
terminal
multi-function output terminal and
relay settings
multi-function output terminal delay
time settings
Multi-function relay 1 item(Relay 1)
Multi-function relay 2 item(Relay 2)
multi-function relay on/off control
trip output by multi-function output
terminal and relay
Multi-function input terminal
Control
Factory default output
In.65–69
Multi-function input terminal Off filter
Multi-function input terminal On filter
Px terminal setting options
Multi-function key
multi-function output
multi-function output terminal delay
time settings
trip output by multi-function output
terminal and relay
Multi-step speed frequency
Configuration
Speed-L/Speed-M/Speed-H
Ｎ
No motor trip Refer to no motor trip
No Motor Trip
No. of time constant filter
Noise
Low-pass filter
Normal load
NPN mode (Sink)
Ｏ
Operation command
Configuration
fwd/rev command terminal
Keypad
RS-485
run command/rotational direction
configuration
Operation frequency Refer to frequency
setting
Operation Group
Operation noise
Carrier frequency
Frequency jump
Option trip Refer to Option Trip-x
Option Trip-x
Option trip
OU (output terminal function group)
Out Phase Open
Out phase open trip Refer to Out Phase
Open
output block by multi-function terminal
Output terminal Refer to R/S/T terminal