LUMAT LB 9507 - Page 110

To Next Page

To Previous Page

Chapter 7: Quantitative Measurements (LIA...) LB 9507

7-16

L46

08: MASTER CURVE CONC. 2

LAST DISPLAY

Enter the concentration of the 2nd curve point, and so on for all

the curve points defined in L 45.

An error message will be displayed if the entered value is smaller

or equal to the previous value; this prevents incorrect entries.

L47

08: LOW CAL. CONC.

LAST DISPLAY

Enter the concentration of the low calibrator (to readjust the

master curve during measurement).

L48

08: HIGH CAL. CONC.

LAST DISPLAY

Enter the concentration of the high calibrator.

L49

INPUT ALL CORRECT ? YES

YES NO LAST DISPLAY

<YES>: the entered parameters are stored and the program returns

to the main menu (L1).

<NO>: the program returns to the 1st display of the protocol (L41).

Entries and changes are stored only if you terminate the routine via

L49 with <YES>.

READY 7 MAY 00 13:58

MEASURE PROTOCOL -OTHERS-