Chapter 7: Quantitative Measurements (LIA...) LB 9507
7-22
L68
STANDARD CURVE NOT CORRECT
EXIT CHANGE
At this point you can correct the curve points (assuming that there
has been a systematic measurement error or that the tubes have
simply been mixed up). You can also abort the measurement via
<EXIT>.
If you select <CHANGE>, the following display appears:
L68a
08: NSB [RLU] 23
L68b
08: STANDARD 1 [RLU] 30
L68c
08: STANDARD 2 [RLU] 28
etc.
The RLU values of the NSB and standard tubes are displayed one
after the other for editing. You can overwrite the displayed value
or keep it. Confirm the displayed values by pressing <enter>.
After confirmation of the last value you will be asked:
L68d
CHANGES COMPLETE ? YES
YES NO LAST DISPLAY
<LAST DISPLAY> takes you back to the previous display.
<NO> lets you edit the curve points again and returns to display
68. <YES> takes you to display 69:
To Next Page
Loading...