Chapter 7: Quantitative Measurements (LIA...) LB 9507
7-24
L70b
CHANGE STANDARD CURVE:
STANDARDS SMOOTHING LAST DISPLAY
You can correct the standard values or enter a smoothing factor
which differs from the automatic calculation by the program (0 to
99).
The program then returns to display 70.
L70
STANDARD CURVE:
CONTINUE CHANGE PRINT
Pressing <CONTINUE> accepts the standard curve and the
smoothing factor, and the program continues with the
measurement of the control and patient samples.
L71
CTRL # 1 REPL # 2 TUBE # 14
INSERT TUBE ...
Load the requested control tube and press the <start> button.
The control and patient samples are subsequently measured in
sequence, as defined in the protocol.
To Next Page
Loading...