MacDon R113 - Page 232

214713 224 Revision A
üü
Item
Reference
Check that cutterbar doors are unbolted from center
channel frame, shipping wire is removed from
cutterbar curtains, and cutterbar curtains are
hanging properly.
5.7 Unpacking Curtains, page 110
Grease all bearings and drivelines. 6.2 Lubrication Points, page 121
Check conditioner roll timing gearbox lubricant.
7.7 Checking and Adding Conditioner Roll Timing
Gearbox Lubricant, page 134
Check disc mower roll timing gearbox lubricant.
7.8 Checking and Adding Disc Mower Drive
Gearbox Lubricant, page 135
Check forward and rear swivel gearbox lubricant.
7.9 Checking and Lubricating Forward and Rear
Swivel Gearboxes, page 136
Check cutterbar lubricant.
Check clutch operation. 7.17 Checking Clutch Operation, page 147
Check cutterbar area carefully for loose parts and
hardware on the cutterbar.
WARNING
These objects can be ejected with considerable
force when the machine is started, and may result
in serious injury or machine damage.
—
Run-Up Procedure 7.18 Running up the Header, page 151
Check hydraulic hose and wiring harness routing to
ensure adequate clearance when raising, lowering or
swinging the header.
—
Check that tail lights and hazard lights are functional. 7.15 Checking Lights, page 145
Post Run-Up Check – Stop Engine
Check belt drive for proper idler alignment and
overheating bearings.
7.3 Checking Conditioner Drive Belt, page 129
Check for hydraulic leaks. —
Check that header manuals are in storage
compartment.
7.16 Checking Manuals, page 146
Date Checked: Checked by:
REFERENCE