Mahr Digimar 817 CLM - Page 24

24
Mahr GmbH • Digimar 817 CLM
Enter the traverse path
Display only the diameter
Display a perpendicularity graphic (curve)
Accept the maximum value
Display the diameter
Error character number Z
Active 2D
Quit system
Taper measurement
Characteristic
Accept straightness value
Accept perpendicularity value
Display a straightness graphic (curve)
Accept the minimum value
Bar graph
Error character number X
Deactivate 2D
Change the production data
Taper probe
1.3.5.3 Symbols - display
Bore from above Bore from below Shaft from below Shaft from above
Bore Shaft Distance, bar Distance
Contacting from above Contacting from below Symmetry Position
Min Max Distance, groove Internal angle Perpendicularity
Display diameter External angle Taper Index circle
Coordinate Straightness Distance 2D
M =
M =
M =
MIN
Z
M =
Ø
M =
MAX
Ø
?
z
?
x
2D
ON
2D
OFF
A
C
B