Alarms for UMS – Class and MAN Diesel & Turbo requirements
ABS
BV
CCS
DNV
GL
KR
LR
NK
RINA
RS
IACS
MAN Diesel
Sensor and
function Point of location
Fuel oil
1 1 1 1 1 1 1 1 1 1 1 1 PT 8001 AL Fuel oil, inlet engine
1 1 1 1 1 1 1 1 1 1 1 1 LS 8006 AH Leakage from high pressure pipes
Lubricating oil
1 1 1 1 1 1 1 1 1 1 1 1 TE 8106 AH Thrust bearing segment
1 1 1 1 1 1 1 1 1 1 1 1 PT 8108 AL Lubricating oil inlet to main engine
1 1 1 1 1 1 1 1 1 1 1 1 TE 8112 AH Lubricating oil inlet to main engine
1 1 1 1 1 1 1 1 1 1 1 TE 8113 AH Piston cooling oil outlet/cylinder
1 1 1 1 1 1 1 1 1 1 1 FS 8114 AL Piston cooling oil outlet/cylinder
1 1 1 1 1 1 1 1 1 1 TE 8117 AH Turbocharger lubricating oil outlet from
turbocharger/turbocharger
1 TE 8123 AH Main bearing oil outlet temperature/main bearing
(S40/35ME-B9 only)
1 XC 8126 AH Bearing wear (All types except S40/35ME-B9); sensor
common to XC 8126/27
1 XS 8127 A Bearing wear detector failure (All types except S40/
35ME-B)
1 1 1 1 1 PDS 8140 AH
Lubricating oil differential pressure – cross filter
1 XS 8150 AH Water in lubricating oil; sensor common to XS
8150/51/52
1 XS 8151 AH Water in lubricating oil – too high
1 XS 8152 A Water in lubricating oil sensor not ready
MAN B&W Alpha Lubrication
1 LS 8212 AL Small box for heating element, low level
1 Indicates that the sensor is required.
The sensors in the MAN Diesel and relevant Class columns are included in the basic Extent of Delivery, EoD: 4 75 127.
The sensor identification codes and functions are listed in Table 18.07.01.
The tables are liable to change without notice, and are subject to latest Class requirements.
Table 18.04.02a: Alarm functions for UMS