MAN B&W 19.01
Page 2 of 2
MAN Diesel
MAN B&W MC/MC-C, ME/MEC/ME-B/GI engines 198 76 203.2
MAN Diesel & Turbo’s recommendations for shop
trial, quay trial and sea trial are available on re-
quest.
In connection with the shop trial test, it is required
to perform a pre-certification survey on engine
plants with FPP or CPP, options: 4 06 201 Engine
test cycle E3 or 4 06 202 Engine test cycle E2 re-
spectively.
Spare Parts
List of spare parts, unrestricted service
The tendency today is for the classification socie-
ties to change their rules such that required spare
parts are changed into recommended spare parts.
MAN Diesel & Turbo, however, has decided to
keep a set of spare parts included in the basic
extent of delivery, EoD: 4 87 601, covering the
requirements and recommendations of the major
classification societies, see Section 19.06.
This amount is to be considered as minimum
safety stock for emergency situations.
Additional spare parts recommended by
MAN Diesel & Turbo
The abovementioned set of spare parts can be
extended with the ‘Additional Spare Parts Rec-
ommended by MAN Diesel & Turbo’, option: 4 87
603, which facilitates maintenance because, in
that case, all the components such as gaskets,
sealings, etc. required for an overhaul will be read-
ily available, see Section 19.07.
Wearing parts
The consumable spare parts for a certain period
are not included in the above mentioned sets, but
can be ordered for the first 1, 2, up to 10 years’
service of a new engine, option: 4 87 629.
The wearing parts that, based on our service
experience, are estimated to be required, are
listed with service hours in Tables 19.08.01 and
19.08.02.
Large spare parts, dimensions and masses
The approximate dimensions and masses of the
larger spare parts are indicated in Section 19.09.
A complete list will be delivered by the engine
maker.
Tools
List of standard tools
The engine is delivered with the necessary special
tools for overhauling purposes. The extent, dimen-
sions and masses of the main tools is stated in
Section 19.10. A complete list will be delivered by
the engine maker.
Tool panels
Most of the tools are arranged on steel plate pan-
els, EoD: 4 88 660, see Section 19.11 ‘Tool Panels’.
It is recommended to place the panels close to the
location where the overhaul is to be carried out.
To Next Page
Loading...
Need help?
General
