WARNING
Tipping Hazard!
Prevent the possibility of being crushed or seriously
injured. Exercise care when the load block is standing in
the vertical position, since the potential for tipping exists.
Potential causes of tipping are unstable work area, boom
movement, and the reeving process. If work area is
unstable, lay the block flat on the side plate.
FIGURE 4-72
2 PART
3 PART
4 PART
Dead End Here
for 3 Parts
Load Block
Fixed
Jib Point
Universal Anchor
Joint (1)
Dead End Here
for 2 or 4 Parts
The universal anchor joint (1) must be removed
when 2-or-4-part line is dead ended at upper
dead end lug or when 3-part line is used
Jib
Point
Load
Block
Load-
Sensing
Sheaves
STANDARD LIFTCRANE
#132 Fixed Jib
To Next Page
Loading...
Need help?
General
