Maintenance work on the carrier
7.4 Fuel system
16.08.2018
Maintenance manual 3 302 577 en 7 - 33
GMK7450
Changing the filter
• Place a receptacle under the filter (1).
• Remove the filter (1).
• Fill a new filter (1) with clean consumable
and screw it up (lightly grease the gasket).
• Remove the receptacle.
Establishing an operational status
• Open the valve (2) – lever parallel to the line.
• Close the valve – lever (1) at right angles to
the line.
• Remove the receptacle.
H
If you have used a clean receptacle, you can refill the fuel tank with the con-
sumable using a filter.
Otherwise dispose of the consumable properly.
H
It is not necessary to bleed air from the fuel line when starting this engine.
• Start the engine and check for leaks.
To Next Page
Loading...
