Manitowoc GROVE GMK7450 User Manual

Maintenance work on the carrier
7.18 Other maintenance work
7 - 120 3 302 577 en Maintenance manual
GMK7450
16.08.2018
7.18.2 Lubricating the outrigger beams
•
Also adhere to the à Run-in regulations, P. 4 - 1.
Grease, spare
parts, tools
– Brush or roller.
• Fully extend all outrigger beams;
à Operating manual.
• Apply the grease to both sides of the slide
faces (1) on all the outrigger beams.
• Extend and retract the outrigger beams sev-
eral times.
• Remove any excess grease.
• Clean the uncovered end (2) of the outrigger
cylinder and bearing surfaces on the outrig-
ger pad by removing old grease, dirt parti-
cles and rust.
• Spray the uncovered end (2), making sure
the grease coating is evenly distributed.
After every high-pressure cleaning operation on the truck crane
• Lubricate the outrigger beams.
M 1
Lubricating
grease
Designation
to DIN 51502
Specifications
Classification
GROVE part no.
Grease KP - 1K - 50 DIN 51825 03233369
Spray Spray on Berulub; 0.5 litres
(spray-on spray)
01929824
G
Risk of crushing by extending outrigger beams!
Ensure that there is sufficient room around the crane. Warn any persons
nearby before extending the
outrigger beams.
Observe the safety instructions in the operating manual.

Manitowoc GROVE GMK7450 Specifications

General

Brand	Manitowoc
Model	GROVE GMK7450
Category	Construction Equipment
Language	English