Maintenance work on the carrier
7.10 Vehicle brake
16.08.2018
Maintenance manual 3 302 577 en 7 - 75
GMK7450
Having repairs
performed
• Do not perform repair work on the vehicle brakes; à Safety instructions,
P. 7 - 74.
• All repair work on the vehicle brakes may only be performed by
Manitowoc Crane Care or an authorised GROVE dealer or an authorised
specialist workshop with specially trained repair crew.
• Make sure that only original spare parts are used; à Spare parts and tools,
P. 7 - 73.
Allow the brakes
to run in
New brake lin
ings do not provide optimal braking and must therefore be run
in by periodic braking.
• Perform a test drive to make sure that the new brake pads are sufficiently
run in before putting the truck crane into normal operation.
G
Risk of accidents due to uneven braking.
If the brake linings are only replaced on one side of the axle line then the
wheels have an un
even braking force.
Always have the brake linings replaced on both ends of the axle li
ne.
S
Risk of damage to the brakes when running them in!
Constant or heavy braking at high speeds can overheat the brakes and
damage them.
The brakes must only be run in through periodic braking.
This must first be done at low speed and then later at medium speed.
To Next Page
Loading...
Need help?
General
