Maintenance work on the superstructure
8.8 Slewing bearing
8 - 60 3 302 577 en Maintenance manual
GMK7450
16.08.2018
First lubrication
• Remove the plate (1).
• Remove the old grease from all the gear
teeth (2).
• Apply a thin layer of new grease to all the
gear teeth and allow it to penetrate for about
10 minutes.
• Apply a second, thicker layer of grease and
allow it to penetrate for about 30 minutes.
• Attach the plate.
Subsequent lubrication
• Remove the plate (1).
• Apply new grease to all the gear teeth (2).
• Allow it to penetrate for about 30 minutes.
• Attach the plate.
To Next Page
Loading...
Need help?
General
