Operator Maintenance 101
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
!
4. Place the charger onto a clean and level worktop.
5. Using the blower brush, remove paper dust and other
unwanted particles.
6. Clean the wire using the wire cleaning tool. After having
finished this procedure the wire should be completely smooth.
7. Replace the charger in its original position and fasten
the knurled screw to secure the charger.
8. Close the waste toner unit.
Make sure the bar has engaged.
9. Close the printer’s front cover.
To Next Page
Loading...
