Microplex SOLID F90 HD - Configuration of Network Parameters (IP Address, e.g.)

80 Panel Functions
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
5.28. Configuration of Network Parameters (IP Address, e.g.)
The functions of the submenu Network are used to set the
parameters for connecting the printer to a network (Ethernet).
Setting the IP address manually:
ON LINE
SAVE
SAVE
SAVE
SAVE
SAVE
ON LINE
Panel display
[SOLID F90 ]
[Menu Level 1 ]
( ( (
[Network
]
[Timeout
]
( ( (
[IP Assign ]
[Off
]
( ( (
[Manual
]
[IP Address
]
[1
92.168.002.002 ]
( ( (
[192.168.010.123
]
[Saved !
]
Notes
Turn the printer OFF LINE with this key.
Press one of the ARROW keys until
[Network ] is displayed.
Press the SAVE key to select the
Network menu.
Press one of the ARROW keys until
[IP Assign ] is displayed
.
Press the SAVE key to select the
IP Assing m
enu.
The current setting value is
displayed.
Press one of the ARROW keys until
[Manual ] is displayed.
Press the SAVE key to set the
IP address manually.
Pressing one of the ARROW keys
changes the value of the current digit
(left digit firs
t, in this example: 1).
Pressing the SAVE key moves you to
the next position (the MENU key moves
you back, if need be).
The new IP address is saved as setup
value.
The printer is turned ON LINE again.