Microplex SOLID F90 HD - Printer Cleaning

Printer Cleaning 83
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
6. Printer Cleaning
!
By a regular and conscientious performance of the following
operations, the printer is guaranteed to always work at an
optimum reliability.
After the printing of about 20,000 pages A4 (print density 5 %;
compare chapter 10 Specifications) the components listed in this
chapter should be cleaned.
Please note:
The printer is provided with a drum counter.
Although this counter only records the revolutions of the drum,
the meter readings can be used to calculate values for the
“number of pages”. For every conversion you have to know the
page length of the printjob and to consider the following:
One digit of the counter corresponds to a page length of
14.8 inch, because this is the circumference of the drum.
Example: If 20,000 pages A4 portrait Two-Up have been printed
the number shown by the counter is approx. 7,900.
- Use a neutral detergent or water on a lintfree cloth to
remove dust or grease from the cover.
- Do not use detergents or any other devices or tools not
mentioned in this manual to avoid damages and
unnecessary costs of repairs.
- Please be especially careful to avoid damaging
mechanical or electronic modules.
Turn off the SOLID F90 HD printer and pull the power plug.
M
ake sure, the printer has been switched off for at least
15 minutes before you start cleaning.