Microplex SOLID F90 HD - Setting to Factory Default

66 Panel Functions
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
5.18. Setting to Factory Default
This function back-outs all configurations to factory defaults.
ON LINE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[SOLID F90
HD ]
[Menu Level 1 ]
( ( (
[Configuration ]
[Interface ]
( ( (
[Factory Default ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press one of the ARROW keys until
[Configurat
ion ] is displayed.
Press one of the ARROW keys until
[Factory Default ] is dis
played.
Only if you press the SAVE key a
second time the configuration will be
back-outed to factory defaults.
The printer is turned ON LINE
again.