Microplex SOLID F90 HD - Print Density Setting

Panel Functions 79
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
5.27. Print Density Setting
Using this function the density of the printed characters can be
changed.
ON LINE
SAVE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[
SOLID F90
HD ]
[Menu Level 1 ]
( ( (
[Engine ]
[Resolution ]
( ( (
[Print Density ]
[Print Density 96 ]
( ( (
[Print Density 104 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this
key.
Press one of the ARROW keys until
[Engine ] is displ
ayed.
Press one of the ARROW keys until
[Print Density ] is displayed.
96 = currently set value. (Default
value = 88).
Press one of the ARROW keys to
change the density.
Values from 0 up to 152 are settable.
The print density is increased, the
print image gets darker.
Now the new value is saved.
In addition this new value can be
saved as setup value (
using the SAVE
key), before the printer is turned ON
LINE again.