78 Panel Functions
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
5.26. Number of Characters per Inch Setting (Character Spacing)
This function sets the number of characters per inch. This setting is
effective only in case of using a line printer emulation.
With a small number of characters per inch, character spacing will be
relatively large. (Ref. IDOL Programming Manual).
ON LINE
SAVE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[
SOLID F90
HD ]
[Menu Level 1 ]
( ( (
[Page Menu
]
[Font Number
]
( ( (
[Char. Spacing
]
[Digit4 0
13.3 ]
( ( (
[Digit1 012.0
]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press one of the ARROW keys until
[Page Menu ] is displayed.
Press one of the ARROW keys until
[Char. Spacing ] is displayed.
13.3 cpi = currently set value.
(
characters per inch).
Pressing one of the ARROW keys changes the
value of the current digit (Digit 4 = left
position, in this example: 0). Pressing the
SAVE key moves you to the next digit (the
MENU key moves you back).
The number of characters per inch
was reduced to 12 cpi.
In addition this new value can be saved as
setup value
(using the SAVE key), before the
printer is turned ON LINE again.
To Next Page
Loading...
