Microplex SOLID F90 HD - _______________________________________________________________________________________________

40 Operation and Menu Structure
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
Functions / Changing of function values:
SAVE
MENU
Within one function the value can be changed by pressing the
ARROW ke
ys.
In case of a multi-digit function value the value of the currently chosen
digit will be changed.
In case of a multi-digit function value pressing the SAVE key switches
to the next position of the function value.
Pressing the MENU key switches to the previous digit of the function
value.
Please note: If you press the MENU key although the absolute left
digit of the function value is still arrived, the changing
procedure will be cancelled and this moves you to the
next menu level above.
If you press the SAVE key although the absolute right
digit (digit 1) of the function value is still arrived, the
currently displayed function value is stored.
SAVE
[Save as Setup? ]
SAVE
MENU
Pressing the SAVE key the currentl
y displayed function value is
confirmed respectively the displayed function is activated. The
changes are stored temporary. (This means, the changes are saved
only until the next printer power off).
After this you have to decide, if you want to save the changes
permanent (Save as setup).
To select such changes permanently, the
user must press the SAVE key
one more time. These permanent changes in printer configuration are
active each time the printer is turned on again.
If the MENU key is pressed instead, the cha
nges are only stored
temporary (not saved as setup). (This key takes the user to the
respective previous menu level).