Microplex SOLID F90 HD - Paper Width Adjusting (Format Width)

58 Panel Functions
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
5.11. Paper Width Adjusting (Format Width)
This function is used to adjust the format width (print width) to the
actually used paper format.
ON LINE
SAVE
SAVE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[SOLID F90
HD ]
[Menu Level 1 ]
( ( (
[Paper Menu ]
[Stacker Select ]
( ( (
[Paper Width ]
[in inch ]
( ( (
[Digit4 0
8.51]
( ( (
[Digit1 08.53
]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press one of the ARROW keys until
[Paper Menu ] is displayed.
Press the SAVE key to select the p
aper
menu.
Press one of the ARROW keys until
[Paper Width
] is displayed.
Press the SAVE key to adjust the format
width to the paper widt
h.
Inch = currently selected measuring unit
(alternat
ive the measuring units mm or dot
can be chosen with the ARROW keys).
Pressing one of the ARROW keys changes
the value of the current position
(Digit4 = left digit, in this example: 0).
Pressing the SAVE key moves you to the
next digit (the MENU key moves you back).
The maximum adjustable format width is
14.72 inches.
The format width is changed to 8.53
inches.
In addition this new value can be saved as
setup value
(using the SAVE key), before
the printer is turned ON LINE again.
Note: Information for „Paper Request“ can be found in section 5.9 Page Length Adjustment.