Microplex SOLID F90 HD - Measures for Transport and Shipping (Repacking); Repacking Procedures

Measures for Transport and Shipping 147
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
9. Measures for Transport and Shipping (Repacking)
!
The Printer is shipped with special packing material and fixing measures.
It is recommended to store the boxes and those packing materials.
In case of further shipping or returning of the products they
must be repacked in the original way in order to avoid
damaging during transportation.
The following list gives you an overview of the working steps necessary
for repacking. Pay attention to the notices located on the products and
the hints given in the Service Manual as well.
If you are not familiar with any of the working steps please ask your
service engineer or your supplier.
• Remove the printer’s optional devices
(for example: stacker …).
• Remove the Waste Toner Bottle from the printer and seal it.
• Remove the Developer Unit.
Close carefully the toner input and output holes
(using paper stripes sealed with adhesive tape, e.g.).
Put the Developer Unit into its original box.
• Remove the Drum from the printer and pack it lightproof into its
original box.
• Lock all moveable parts of the printer (use all original transport
safety devices, adhesive fasteners and so on).
Repack all items in their original packing material and ship them in the
original boxes.