Microplex SOLID F90 HD - Selecting the Number of Printpages per Page Format (Two-Up Mode)

56 Panel Functions
_______________________________________________________________________________________________
________________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F90 HD Edition 1.0
5.10. Selecting the Number of Printpages per Page Format (Two-Up Mode)
Activating this function determines the arrangement of several
printpages per page format (paper width resp. page length).
ON LINE
SAVE
SAVE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel displ
ay
[SOLID F90 HD ]
[Menu Level 1 ]
( ( (
[Paper Menu ]
[Stacker Select ]
( ( (
[Two-Up Mode ]
[Y-Direction ]
( ( (
[X-Direction ]
[X-Direction: OFF ]
( ( (
[X-Direction: 2 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press one of the ARROW keys until
[Paper Menu ] is displayed.
Press the SAVE key to select the p
aper
menu.
Press one of the ARROW keys until
[Two-Up Mode
] is displayed.
Press the SAVE key to select the function
Two-Up mode.
Press one o
f the ARROW keys to effect
the adjustment of the Two-Up mode to the
X-direction (cross to the print direction).
Press the SAVE key to set the Two-Up
mode.
By pressing the ARROW UP or DOWN
key the
number of print pages cross to the
print direction can be altered. The
maximum number of print pages being
adjustable next to each other is 9.
Here the number of print pages per
format widt
h was altered to 2.
In addition this new value can be saved
as setup value (using the SAVE
key),
before the printer is turned ON LINE
again.